Products
Ozeki 10
SMS
Ozeki NG SMS Gateway
Message Server 6
SMS Wall
IP SMS Gateway
Android SMS
Excel SMS
Excel client
Installation steps
Setup and connect the GSM device
Deploy Ozeki SMS Server
Install the GSM driver
Start the application
Create a new user
Configuration
Screenshots
Bulk Messenger
Cluster
Developer tools
Robots
Hardware
Installer
Technology
Company


Setup and connect the GSM device

Before starting to install the Ozeki SMS application you need to make some initial settings on your GSM device:

- All the PIN codes and security locks should be switched off
- The voice and data calls should be redirected to another phone number
- All SMS messages stored in the phone or the SIM card should be deleted
- The phone number of SMS Service Center should be set

When you finished all the settings you need to test your phone by sending SMS messages manually.

As the next step you have to attach your device to the PC with a phone-to-pc data cable as it can be seen on Figure 1.


Figure 1 - Attaching the GSM device to the PC with a phone-to-pc datacable.

If you are in a situation, where IR is you choice, to use Infrared (IR),you must enable your infrared port on the phone. (Sometimes you have to turn it on in the PC as well). When this is done, you should place the phone within the range of the IR receiver on the PC. When the PC and the phone begin to communicate over IR, you will see an icon in the bottom right hand side of the screen (Figure 2).


Figure 2 - IR connection between the cell phone and the PC


Copyright © 2000- - Ozeki Ltd | info@ozeki.hu
Home > Products > SMS > Excel SMS > Excel client > Installation steps > Setup and connect the GSM device
Legal | Privacy policy | Terms of use
Page: 735 | Login | 34.238.192.150